Condensation on the pipes has a direct effect on the microclimate in the house, and can also cause all sorts of problems in the bathroom. That is why this problem should be solved, and as soon as possible. However, you should not grab the tool without understanding the essence of the issue.
Reasons for the formation of condensation
It is quite difficult to single out any one reason for the formation of condensate on pipes. This is because in the vast majority of cases, the reasons for the appearance of moisture are triggered in a complex, and not separately. Moreover, they act on the entire pipe, and not on any part of it. There are, of course, exceptions.
The first reason for the appearance of condensation is the temperature difference between the water in the pipe and the air outside. The second reason is poor ventilation of the room, which does not cope with the timely removal of moisture. The third reason is the incorrect wiring of the hot water and cold water mains (they are too close to each other). The fourth reason is the failure of sanitary devices.
Identifying the cause of condensation
In order to correctly identify the cause of condensation in the bathroom, you must act in a specific order. The first step is to check the ventilation. To do this, it is enough to slightly open the window and bring a paper sheet to it. With proper operation, the sheet must adhere to the grate.
The second step will be to inspect faucets, valves, toilet bowl. Be sure to check these items for problems. Finally, do not hesitate to go to the neighbors upstairs and ask if they have a leak.
Quick solutions
Most often, it turns out to remove condensate from cold water pipes and other surfaces by repairing the ventilation (as well as by repairing the tank, valves or mixer). It is also recommended to ventilate the room more often. Some of these things can be done by hand. To carry out repairs to others (for example, ventilation), you will have to call qualified specialists.
Coping with temperature differences
There is only one effective way to deal with temperature differences - insulation of cold water supply lines. This will require the use of heat-insulating materials. As a means of insulation, you can choose a universal material for insulation foam polystyrene, mineral wool (just winding on pipes), polyurethane foam or polyethylene foam. You can also try using a plastic pipe with a large cross-section (fits over the main one).
Note: before taking on any work, you need to dry the pipe from condensation.
In addition to the above, you can use “ Isollat »- special paint for pipe insulation. Before starting work, the pipe must be dried, cleaned of dirt and rust. After that, a layer of primer is applied, and after it has dried, an insulating paint. It is applied in layers. In total, you need to make 5 pieces. Each layer should dry for about an hour.
Want to know even more interesting things? How about reading about 9 things you shouldn't throw in the sink and toilet so you don't have to deal with the plumber in the foreseeable future.